Mining in Manitoba |
Delay Systems |
Mining Systems |
||
|
Delay, or rotational, shooting has many advantages over instantaneous firing in almost all types of blasting. It generally gives better fragmentation, more efficient use of the explosive, reduced vibration and concussion, and better control of the rock. For these, and sometimes other reasons, most blasting operations are now conducted with a delay system. It is probable that the first use of delay firing was in tunnels. The centre was shot out first and then successive rings around it until the desired tunnel dimensions were reached. The procedure was to cut all the fuses to the same length and then trim them toward the centre; for example, the outside ring of fuses would be full length, the next ring a few centimetres shorter, and so on. In addition, the fuses were lit from the centre out, causing a little more delay in the desired direction. This method of shooting could not be used until Bickford's safety fuse, which had a uniform burning speed, became available. Delay electric blasting caps are the most commonly used means for obtaining rotational firing. They are of two types: (1) the so-called regular delay, which has been in use since the early 1900s, and (2) the short-interval, or millisecond, delay, which was introduced about 1943. Except for a delay element placed between the ignition and primer charges, they are the same as instantaneous electric caps. A typical series of regular delays would comprise 14 periods ranging from a few milliseconds to about 12 seconds. To avoid overlapping and because there is some variation in the burning speed of the delay element, the intervals are made longer in the higher periods; for example, the delay between periods 1 and 2 might be 0.8 second, whereas for 13 and 14 it might be 1.5 seconds. Ordinary delays have been largely replaced by short-interval delays but are still used to a considerable extent for such purposes as driving tunnels and sinking shafts. The periods in short-interval delays are usually separated by 25 milliseconds up to 200 milliseconds, by 50 up to 500, and by 100 up to 1,000 (one second). This close spacing gives improved fragmentation, the ability to fire many holes with hardly any more vibration or concussion than would be obtained with one hole, less chance that the detonation of one hole will cut off an adjacent hole, and a reduction in the quantity and cost of explosives. Short-interval delays are used above ground, in such work as excavating and quarrying, and for almost all types of underground mining. Their development is one of the major advances in explosives. Delay elements for electric blasting caps function in about the same way as black powder in safety fuse, except that the chemical mixtures used are much faster. At times the delay mixture is simply pressed on top of the primer mix. Usually, however, it is put in the centre of a metallic tube in lengths that will give the desired delay interval.
|
Black Powder
Liquid Oxygen
|